Triner Scale T-1000 TELESET - Manual (Page 11)

17 16
Operator manual T-1000 TELESET Registers
The T-1000 has a total of eight registers that
give numeric information about your meter.
You can scroll through all of the registers by
pressing the ‘R’ key. Each selected register
will display its value while the register’s
number appears in the bottom left corner of
the display next to the letter ‘R’.
The information in each register is as follows:
Information displayed
Amount of available postage,
called the descending register
Amount of postage used, called the
ascending register
Total of registers 1 and 2, called
the control total
Total letters metered, excluding
zero imprints
High postage value
(for programming, see section 8.2)
Low postage warning (Limit),
(see section 8.3)
Service programming mode for
use by FP dealer.
Total letters metered, including
zero imprints
After pressing the ‘C’ key the most recently
used postage amount will appear in the
display.
To print out the register information see
section 6.2 PRINTING ACCOUNT
INFORMATION on page 19.
5 Registers
R 1
R 2
R 3
R 4
R 5
R 6
R 7
R 8