Trio Avionics Wing Servo Mount Installation for RV-7, 8, 9 and 10 - Manual (Page 2)

Above: Gold Standard Servo as
delivered from Trio
Original Crank Arm
Points Down
Step 1:
Rotate the existing Servo Crank Arm 90 degrees.
Crank arm must be rotated 90
degrees Counter-Clockwise. When
complete, the crank arm should
point to the 3 o’clock position as
shown.
A) Point the crank arm to the six o’clock position,
as shown at left. Mark the crank arm (and
the hub it mounts to) at the twelve o’clock
position
B)
Remove the screws attaching the crank
arm. BEFORE DOING THIS READ
Appendix A in the back of this guide!
Failure to do so will result in broken
fasteners !
(Note: New servos are now shipped with the crank arm removed)
C) With the hub index mark at the 12 o’clock
position, rotate the crank arm to the 3
o’clock position.
D) Reinstall the screws in accordance with
Appendix A.
Using six #6 screws and locknuts, mount the servo to the bracket. Set the assembly aside
and let’s go to the wing.
Step 2