Trio Avionics Wing Servo Mount Installation for RV-7, 8, 9 and 10 - Manual (Page 4)

Servo
mounting
detail
Step 7:
Install the bracket/servo assembly in the wing. Install the 4 AN3 bolts to secure the
assembly to the spar (Use the same bolts that you removed from these positions.)
“Knee Brace” faces down
when installed in wing.
Install the push rod. There are two AN3 bolts of different length. The longer AN3 bolt is
used for attachment to the Servo Crank Arm. The shorter AN3 bolt is for attachment to
the Aileron Bell Crank. The image (below) shows the hardware components and
placement.
NOTE
Step 6:
•TWO standard thickness washers on
the inside of each rod end bearing.
•ONE large diameter washer on the
outside of each rod end bearing