TruTrak EFIS AP (8300-057C) - Manual (Page 10)

SETUP SCREENS
STYLE, ATT, ZERO, INFO, UNITS, BALL, ALERTS, SPEEDS, SERIAL, LAT AP, YD, VRT AP,
AUDIO
To enter the setup screen the press
the right knob until SETUP shows
below the HSI then click the soft k
below SETUP at the same time.
Click the button below any selection
to enter and adjust that function.
Click the MORE button or rotate
the right knob to progress through
the different setup selections.
ey
With a dual EFIS system, most
setting that apply to both the EFIS
and EMS will change on both units
when set on one. With the EDM
(Engine Data Module) option,
engine information can be selected
under the ENGINE page.
See EMS installation manual for
more information.
Rotate the right knob NEXT on the first page to enter the AP setup pages.
Click the right knob to return to the main screen.
STYLE
Click ether ROUND gauge or RECT tape style airspeed and altimeter
gauges.
Click the right knob to return to the SETUP screen.
ATT & ZERO
Click ATT, OFF or ON to select
aircraft attitude indication in the
center of the EFIS horizon. This
will display the VSI indication on
the left side with round style and on
the right side with tape style gauges.
The attitude can be zeroed for level
flight for different aircraft by
clicking the ZERO soft key button
at any time.
TruTrak Flight Systems 8 EFIS Autopilot Installation Manual
April 2009 8300-057 Rev D