TruTrak EMS BU (8300-065) - Manual (Page 9)

TruTrak Flight Systems 7 EMS Installation Manual
JUNE 2009 8300-065 Rev D
SWITCHES (CONTACTS)
Select the switch (SW # 1) to change
the label on. Select LABEL, now
the left knob will select the
alphanumerical digits and the right
knob will move the cursor position
(
green ). Select the name for this
switch, there are seven (7) digits
available. Press and release the right
knob (back) to return to the last
page. Select OPEN or CLOSED,
select TEXT to change the label
displayed when the contact is open
or closed. Select COLOR to change
the color that is displayed in ether
switch position.
Press and release the right knob
(back) repeatedly to return to the
beginning.
CALIBRATION
FUEL, TACH, SNSRS, FLAPS, TRIM, SPEEDS, & BALL
These pages allow the selection and calibration of the Fuel level, Tach, Sensors, Flaps and Trim
indicators. Also to set the Baud rate and center the ball in the T&B after installation.
FUEL
The type of and # of fuel sensors MUST be selected first (see CONFIG & SNSRS).
Calibration of tank / guages, there are a total of 15 PTs (calibration
points) possible, not all are necessary.
Select the tank to calibrate, with the tank empty, the first PT #0 is 0
GAL, press [enter]. Add fuel, in whole gallons until the number of
GAL over the displayed gauge just starts to move. Wait until the
number stabalizes. Enter the gallons added by rotating the left knob
and press [enter], PT #1. The gauge colors and number of GAL are not
correct until the calibration are complete. Continue adding fuel, each
PT# should have the total amount of fuel in the tank at that time and
wait until the number stabalizes. When the number displayed STOPS
changing when adding fuel, STOP. This is the last PT # even if the
tank is not full, enter the total gallons in the tank by rotating the left
knob, wait until the number stabalizes. Press DONE.
The sender can not measure fuel past this point. This is NOT to total
fuel used in calcuating remaning fuel. Only the @ amount of fuel in
the tanks.