TruTrak Vizion 380-385 Install manual - Manual (Page 13)

TruTrak Flight Systems 11 Vizion 380/385 Series Autopilot Installation Manual
December 2013 8300-086 Rev IR
Note: The default baud rate is 4800. This is the baud rate that will entered into the autopilot in the setup mode. The
yellow wire is the Data out TX wire.
Now the AvMap EKP IV is correctly set up to provide the RS-232 serial output required by your TruTrak autopilot.
Garmin 155XL/250XL/300XL
Garmin 155XL/250XL/300XL connections to TruTrak autopilot
J1 on
Garmin unit
Signal Name
(Garmin)
Signal Name
(TruTrak)
P101 on
TruTrak Vizion
19 GPS RS 232 OUT 2 Primary Serial Input 17
16 GPS ARINC 429 OUT A ARINC-A 14
15 GPS ARINC 429 OUT B ARINC-B 15
Press & hold MSG, rotate outer knob until I/O setup page is displayed. Press CRSR twice and rotate inner knob to select
“plotting” for output to autopilot. Rotate outer knob to advance cursor to the baud rate field, select 9600. Press CRSR
to finish.
To set the ARINC output. Remove the data cards turn the unit on. Press “enter” in response to “Select operating mode
Normal?” Press “enter” in response to “No Jeppesen database rte / prx limited to user wpts ok?” After the satellite
status page is displayed for 5 seconds the unit may be turned off.
With power OFF press and hold the ENT key and turn the power on (release the ENT key when the display activates).
You should be in the TEST MODE. Press the CRSR key then rotate the outer knob to Select ARINC 429 CHANNEL. Press
the CRSR key then rotate the inner knob to advance to OUTPUT and select “w/o GAMA labels”
Garmin 430W and 530W
Garmin 430 and 530 connections to TruTrak autopilot
P4001 [P5001] on
Garmin 430 [530]
Signal Name
(Garmin)
Signal Name
(TruTrak)
P101 on
TruTrak Vizion
56 GPS RS 232 OUT 1 Primary Serial Input 17
46 GPS ARINC 429 OUT A ARINC-A 14
47 GPS ARINC 429 OUT B ARINC-B 15
Power 430/530 up and turn it on while holding down the ENT key. Release the ENT key when the display activates.
After the data base pages, the first page displayed is the MAIN ARINC 429 CONFIG page. While in Configuration mode,
pages can be selected by ensuring the cursor is off and rotating the small right knob. To change data on the displayed
Configuration Page, press the small right knob (CRSR) to turn on the cursor. Turn the large right knob to change
between data fields. Turn the large or small right knob to change a field that the cursor is on. Once you have made the
desired selection, press the ENT key to accept the entry. The second startup page will test the RS 232 and ARINC inputs
on the ground, a good RS 232 connection will display GPS NAV and the asterisk, ARINC will display GPSS and move the
stick right and left.
With the MAIN ARINC 429 CONFIG page displayed, on the row labeled OUT, select SPEED  Low
and DATA 429 GAMA. In the VNAV row ENABLE LABELS.
Advance to the MAIN RS232 CONFIG page.
On the row labeled CHNL1, select OUTPUT  Aviation.
Note that for the Garmin units, the autopilot will need to be set for 9600 baud.
UPSAT GX-50/60/65