Tuffy Security 173 - Manual (Page 3)

Page 3 of 8 – 12/20/06 – Rev 11/4/13
4. Install the pre-cut trim seal #10.20 and #10.19 on both sides #8 and #9 as illustrated with the bulb facing the inside of
the enclosure assembly. (See Figure 2a)
5. Install the pre-cut trim seal # 10.21 on both sides #8 and #9 with the bulb overlap protruding toward the inside of the
enclosure assembly. (See Figure 2a)
Figure 2a
6. Install the #5 Brackets to the #8 and #9 sides. The slotted holes in the #5 Brackets should be towards the outside of
the enclosure. The #5 Brackets should be mounted to the inside face of the #8 and #9 sides as illustrated. The #5
Bracket will pass through the slot in the #9 side. (See Figure 2b)