Tuffy Security 247 - Manual (Page 2)

Page 2 of 2 - 10/27/2010 – Rev122006
1. Remove the original seat mounting bolts #8.4 holding the front of the Drivers side seat to the body.
(See Figure 1)
2. Insert the drawer in the mounted position. Make sure the right side seat bracket #8.6 is under the
mounting flange on the Tuffy drawer and the left side seat bracket #8.7 is on top of the mounting
flange on the drawer as illustrated. (See Figure 1)
OPTIONAL SECURITY STEP
WARNING! - Make sure that there is nothing under the vehicle that will be damaged by the drill bit when
drilling. The exhaust is located in that area, be cautious not to touch it when hot.
For additional security remove the drawer from the enclosure (See note above). Mark the spot in the
vehicle floor under the hole in the bottom of the drawer enclosure and drill a 3/8” hole. Fasten using the
included bolt #8.2, washer #8.3 and Nut #8.1. It is recommended to use silicone sealant on any drilled
holes to prevent rusting. (See Figure 1)
3. Fasten the Tuffy drawer down using the original seat mounting bolts #8.4. (See Figure 1)
Figure 1
Call (970)564-1762 for Technical Support