USL DAX-602 - Manual (Page 11)

DAX-602/802 INSTRUCTIONAL MANUAL Ultra
★ Stereo Labs, Inc.
Introduction
The Ethernet interface on the DAX series allows remote monitoring and control of
the device through a web interface. In addition, firmware upgrades are
accomplished through the same web interface
Initial Configuration
The DAX units are shipped with a Dynamic Host Configuration Protocol client
enabled. Further, the DAX supports the use of NETBIOS, so it is possible to
connect to the device by name instead of by IP address.
Using DHCP and NETBIOS
If you have a network with a DHCP server, you should be able to plug the DAX in
to the network. Then, open a web browser and type "DAX" in the address field.
You should see the status page, similar to that shown above.
-11 -