USL DAX-602 - Manual (Page 14)

DAX-602/802 INSTRUCTIONAL MANUAL Ultra
★ Stereo Labs, Inc.
Select the update file provided by USL, then click on "Update DAX." The update
process will take several minutes. When it is almost complete, you will see the
LEDs on the front of the DAX flash. The web browser will then show an empty
screen. You can then type the IP address or host name in the browser address
field to re-establish communications with the unit.
Restore Factory Defaults
You can restore the original factory software, network settings, and configuration
password by disconnecting the power to the DAX, removing the cover, shorting
J8 pins 3 and 4, then connecting the power. During the restore, the LEDs will
flash. When they stop flashing, remove power, remove the short, then apply
power again. The original software and configuration have returned.
DAX-602 Firmware Update Page
Status Page I Configuration Page
Select the file supplied by USL to update the system. After the file uploads successfully, you should
see the front panel LEDs flash, then the DAX-602 should reboot with the new firmware.
In the unlikely event the upload fails and you are unable to access the system, you can restore the
factory firmware and settings by shorting pin 3 to pin 4 on J8, then supplying power to the system.
The front panel LEDs should flash as the firmware is loaded. When they stop flashing, remove the
short on J8 then apply power spin.
Browse Update DAX-602
-14 -