Viconics VT7000 Series Application Guide - Manual (Page 26)

26
Typical Detection Pattern for VI-PIR Lens
Installation Tips
Tip Type Area Of Interest Explanation
PIR Connector Polarized connector is located at bottom left hand corner
of VT7000 series thermostat General Installation
Security Screw A security screw has been provided in the thermostat
box. This screw should be carefully installed in the
intended mounting position located bottom center of
thermostat cover.
Tip Type Area Of Interest Explanation
Initial Power Up &
Commissioning PIR Warm up period PIR Sensor may take up-to 60 seconds after initial warm
up period to detect movement consistent with typical
detection pattern.
Visual indication (Status of PIR) Visual indication of PIR activity for commissioning has
been provided via a blinking LEDs located on the
thermostat cover under the PIR lens. LEDs will be active
while occupant is in field of detection pattern for a period
of 30 minutes after initial power up.
Horizontal
Angle (typical)
Vertical Angle
(typical)