Vizualogic A-1250 Installation Instructions - Manual

1493 Bentley Drive • Corona, CA 92879 • 951-272-1996 • 800-624-7960 • Fax 951-272-1584
www.vizualogic.com
Copyright © 2006 TMI Products, Inc.
All Rights Reserved
99-9138-100 Rev. 1 7/06
Section III – System Set-up/Sub-Menu Controls (continued)
SCREEN – Sets the power-up mode for the monitor when system power is turned on.
• ‘AUTO’ – While in this mode the monitor will resume the last state it was in when the system power
was last turned off.
• ‘ON’ – When system power is turned on, the monitor will always turn on.
• ‘OFF’ – When system power is turned on, the monitor will always remain off. The monitor must be
turned on manually using the power button on the monitor or remote.
DVD MODE – Assigns the headrest identity to ensure proper source identification between Driver DVD,
Passenger DVD, Ext. Aux, and Aux. via the on-screen display (OSD).
NOTE: The dual DVD headrest system’s default setting for the driver’s side is set to 'DRIVER DUAL’ and
'PASS DUAL’ for the passenger side. The single DVD headrest system’s default setting for the driver’s side is
set to 'DRIVER SINGLE’ and 'PASS SINGLE’ for the passenger side. Do not set both screens to DRIVER
DUAL / DRIVER SINGLE or PASS DUAL / PASS SINGLE. These settings must be observed in order to utilize
the integrated FM modulator functions properly.
EXIT – Exits the sub-menu.