Vizualogic A-1260 Troubleshooting Guide - Manual

Troubleshooting Guide for A1260 Headrest Monitors
1. No Picture:
(1) Verify that the Red and Yellow cables that plug into the AV Box cables are
seated properly.
(2) After you have done step (1) if you can see the Menu but there is no image.
Verify that each monitor is properly setup. Hold down the Menu button for
10 seconds until you see the sub menu. Example: Drivers monitor should be
setup as IR channel A and DVD Mode should be Drivers Dual. Passengers
monitor should be setup as IR channel B and DVD Mode should be
Passengers Dual.
(3) Verify the monitor’s source is set to the proper video input mode. Example:
Drivers DVD, Passengers DVD, EXT Aux, Front Aux.
2. No Sound:
(1) Verify that the Red and Yellow cables that plug into the AV Box cables are
seated properly.
(2) Verify that each monitor is properly setup. Example: Drivers monitor should
be setup for IR channel A. Passengers monitor should be setup for IR channel
B.
(3) Verify that the FM Transmitter has been turned on. To turn on the FM
Transmitter make sure you are using the Drivers monitor. Push the Menu
button until you see FM Source. Make sure you set FM Source to the proper
source you want to hear. After the correct source has been selected push the
Menu button one more time to get to the FM Channel. Choose a channel
and tune your FM radio to the same channel. If the sound has a lot of static
then change the FM channel. Make sure if you change the channel to change
the Radio channel as well.
(4) Make sure both Drivers and Passengers IR’s are turned on. Follow step (2)
for the proper procedure.