Vogelzang BX26E - Manual (Page 5)

VGZ-006 / 20120225.0 BX26E-STD / Page 5
ASSEMBLY INSTRUCTIONS
tools required
Safety Glasses
CAUTION: STOVE IS HEAVY. MAKE SURE YOU
HAVE ADEQUATE HELP AND USE PROPER
LIFTING TECHNIQUES WHENEVER MOVING
STOVE.
Refer to diagram and parts lists at back of this manual.
1. Uncrate the stove and remove packing materials
and protective poly bag. (Save exterior cardboard
box for further assembly.)
2. Remove par ts from inside of stove. Par ts
include: one swing top (#9), two lids (#10), one lid
support (#11) one damper collar (#13), one feed
door (#7), one lid lifter (#15), one slide damper (#5),
four legs (#1), hardware pack (#16), and S-Hook
(#17) from inside firebox.
3. Place flattened carton on floor and carefully turn
stove over onto carton.
materials required
(NOTE: The following items are NOT included with your stove)
7. Carefully lift stove upright and place in desired loca-
tion (see following instructions for properly locating
stove).
Screwdrivers
(blade and Phillips types)
5/16” Nut Driver or Ratchet
with 5/16” Socket (for 1/4”
Hex Nuts)
11mm Nut Driver or
Ratchet with 11mm Socket
(for Stove Bolts)
Hearth Gloves
Pencil
6 foot Folding Rule or
Tape Measure
Tin Snips
Drill: Hand or Electric
1/8” dia. Drill Bit
(sheet metal screws)
Flooring Protection: 48˝ x 70˝ as
specified (see page 3)
Chimney Connector Pipe: 6˝
black steel (24 ga. min.) straight or
elbow (as required)
1/2˝ Sheet Metal Screws Chimney: Existing 6˝ Lined
Masonry Chimney or 6˝ I.D.
manufactured chimney listed
to UL 103 HT.
Furnace Cement (manufacturer
recommends Rutland Code 78
or equivalent)
continued on next page
NOTICE: Vogelzang International Corp. grants no warranty, stated or implied, for the installation or maintenance
of your wood stove and assumes no responsibility of any incidental or consequential damages.
4. Attach the rear legs to base of stove with
long stove bolts (B), flat washer (E) and hex nut (F).
5. Attach hearth to bottom
of stove with two short
stove bolts (A), wash-
ers (E) and hex nuts (F).
6. Attach the front legs to
hearth with long stove
bolts (B), flat washers (E)
and hex nuts (F).
ill. A – Hardware Pack
ill. B – Rear Leg Assembly
8. Attach damper collar to rear top surface of stove
using short stove bolts (A) flat washers (E) and hex
nuts (F).
9. Place swing top in po-
sition on top of stove.
To install, position at
approximately 45 de-
gree angle to stove
(dashed lines in ill. F)
until pins drop into lo-
cator holes then swing
into position.
10. Place lid support and
two lids in position on
swing top (see ill. F).
11. Place the slide draft into position on the
hearth. Hold in position with round head stove
bolt (C) and large flat washer (D).
ill. C –
Hearth
Assembly
ill. D –
Front Leg
Assembly
ill. E – Damper Collar