Vogelzang TR001B - Manual (Page 20)

Page 20 | DEFENDER™ Vogelzang International Corp. TR001B | 20120125.0
WIRING DIAGRAM - MODEL F-6 BLOWER OPTION
DOOR GASKET REPLACEMENT
CAUTION: DO NOT OPERATE A STOVE THAT
IS MISSING DOOR GASKET MATERIAL. OVER
FIRING AND UNSAFE OPERATING CONDI-
TIONS MAY RESULT.
PROCEDURE:
1. Ensure appliance is not in operation and is thor-
oughly cooled.
2. Remove old door gasket and clean channel.
3. Using an approved, high temperature gasket ce-
ment, apply a thin coat in bottom of channel.
4. Starting at hinge side of door, work gasket into
channel around door unit, end butt and trim to
length.
5. Close door and allow three to four hours for cement
to set before firing appliance.
BLOWER MAINTENANCE
The optional blower is maintenance free other than
cleaning. Lightly vacuum motor and air inlet to keep free
of dust and dirt.
SERVICE HINTS continued …
NOTICE: ANY REPLACE-
MENT WIRING MUST HAVE
E Q U I VA L E N T I N S U L A -
TION AND TEMPERATURE
RATING (105°C).
CAUTION: MOVING PARTS CAN CAUSE
INJURY. DO NOT OPERATE WITH COVER
REMOVED.
DANGER: SHOCK HAZARD. DISCONNECT
POWER SOURCE BEFORE INSTALLATION
AND WHENEVER SERVICING BLOWER
ASSEMBLY.