WaterChef U9000 - Manual (Page 8)

www.waterchef.com
SETUP & INSTALLATION
6
1. Slide the LED Faucet Ring up Faucet Tubing and onto Faucet
Stem. Next, insert Cable through hole in sink, followed by Faucet
Tubing and Faucet Stem (be careful not to crimp the Cable). (fig. J)
2. From under the sink, guide Cable through the hole in the Spacer
(small side up). Next, slide Cable into the small notched area of
the Spacer hole. Insert the Faucet Tubing through the main area
of the Spacer hole and guide Spacer onto Faucet Stem. Thread
Wing Nut onto Faucet Stem and hand tighten. (fig. K)
Faucet Stem
Blue Tubing
Spacer
Wing Nut
LED Faucet Ring
Cable
Cable
Cable Notch
Sink Cross-Section
Sink Cross-Section
System Faucet
NOTE
Final Faucet positioning may require two people when tightening the Wing Nut.
Be sure Cable remains in the notched area of Spacer hole as you slide the Faucet
Tubing and Stem through the Spacer to avoid damaging the Cable.
Faucet Installation:
IMPORTANT
J
K
TYPICAL UNDER-SINK INSTALLATION
Designer
Faucet
Monitor
Housing
RED Tubing
T-Valve
BLUE Tubing
Cable
HOT COLD