Wilson Audio WATCH Dog Subwoofer Series-2 - Manual (Page 49)

49
Note: Before proceeding with the Control Panel setup and configuration,
please connect your system as outlined in Section 5, which contains valuable
information needed before proceeding further.
Section 6.0 - Control Panel Setup and Final Tuning
Preparation
In order to realize the full potential of your WATCH Dog, we recommend that
you have a trained Wilson Audio Specialist install and perform the final adjustment and
setup of your subwoofer. Your dealer will have personnel trained in the art of WATCH
Dog setup. If you choose to do the installation yourself, here are some guidelines to
assist you. These guidelines come from many years of experience and should be fol-
lowed closely to ensure the best possible result from your WATCH Dog.
You will need the following items:
• Supplied WATCH Dog Setup CD
• Supplied 5/32 T-handled Allen Wrench
• Radio Shack dB Meter
• Pen and paper to make notes
Using the Allen wrench, remove the top clear acrylic cover plate that protects
the control panel. Double check the switch and control settings to ensure that they are
in the proper positions as outlined in Section 5. In this section, you will be adjusting
and fine tuning the WATCH Dog control panel.
Locate the main power switch on the rear of the WATCH Dog, below the ampli-
fier heatsinks. Toggle the switch to the “on” position. This powers the WATCH Dog
into the “standby” mode and can be left on. Locate the power switch on the front of
the WATCH Dog, behind the grille. Depress the switch and check to see that the front
panel LED is illuminated.
C o n t r o l P a n e l S e t u p a n d F i n a l Tu n i n g