Cleaning, Troubleshooting, Generator specifications – Winco HPS9000VE/E User Manual

Page 16: Engine specifications

Advertising
background image

3210-10

16

60706-237

CLEANING

Remove dirt and debris with a cloth or brush. DO
NOT use high pressure spray to clean either the
engine or the generator. This high pressure spray
could contaminate the fuel system and the generator
components.

1. Keep the air inlet screen on both the engine and
generator free of any dirt or debris to insure proper
cooling. At least yearly, remove the blower housing
on the engine and clean the chaff and dirt out of the
engine cooling fi ns and fl ywheel. Clean more often
if necessary. Failure to keep these areas clean may
cause overheating and permanent damage to the
unit.

2. Periodically clean muffl er area to remove all grass,
dirt and combustible debris to prevent a fi re.

3. On engine muffl ers equipped with spark arresters,
the spark arrester must be removed every 50 hours
for cleaning and inspection. Replace if damaged

TROUBLESHOOTING

PROBLEM (SYMPTOMS) POSSIBLE

CAUSES

———————————————————————
Won’t Start

*Low Oil Level.

*Fouled

spark

plug.

*Out

of

fuel.

*Start switch in Off position.

*Fuel valve turn off.

*Plugged

fuel

fi lter.

———————————————————————
Voltage too low

*Engine speed is too low.

*Generator

overloaded.

*Defective

stator.

*Defective

rotor

(fi eld).

*Defective

Capacitor.

———————————————————————
Circuit Breaker

*Defective load.

Trips

*Defective

receptacle.

*Excessive

Load.

———————————————————————
Voltage too high

*Engine speed is too high.

———————————————————————
Generator

*Overloaded.

overheating

*Insuffi cient ventilation.

———————————————————————

No output voltage

*Short in load (disconnect).

*Tripped or defective circuit

breaker.

*Broken or loose wire.

*Defective

receptacle.

*No

residual

magnetism

(in

generator).

*Defective

stator.

*Defective

rotor

(fi eld).

*Shorted

capacitor.

*Shorted diodes on rotor.

*GFCI

Receptacle

tripped.

———————————————————————

GENERATOR SPECIFICATIONS

Generator manufacturer

MECC Alte Spa

Generator model number

S20W-110

Part number

16346-006

Rotor resistance

5.22 Ohms

Stator resistance

0.210 Ohms

Cap winding resistance

0.87 Ohms

Capacitors

35

mF

Capacitor part number

16346-312

ENGINE SPECIFICATIONS

Engine manufacturer

Briggs & Stratton

Engine model number

305447

Type & Code

0003-G1

Spark

plugs

491055

Air

fi lter

394018

Air

fi lter pre-cleaner

272490

Oil

fi lter 6 cm long

492932

Oil

fi lter 9 cm long

491056

Spark plug gap

0.030 in

Armature air gap

0.008 - 0.012 in

Intake valve clearance

0.004 - 0.006 in

Exhaust valve clearance

0.004 - 0.006 in

Oil capacity

46 - 48 oz.

Advertising