Winco RDP-110 - Manual (Page 10)

1-2 RDP-110 General Information 9318100990 Rev E
FUNCTIONS
RDP-110 remote display panel displays the following functions:
•
Switch Not in Auto Alarm
•
Low Coolant Level Alarm
•
High Coolant Temperature Alarm
•
Low Oil Pressure Alarm
• Overcrank Alarm
• Overspeed Alarm
• Emergency Stop Alarm
• Airbox Closed Alarm for RDP-110 X2 or fuel leak/Sender failure for RDP-110 X1.
•
Sender Failure Alarm
•
Display Panel On LED
•
Emergency System Supplying Load LED
•
High Coolant Temperature Pre-alarm
•
Low Coolant Temperature Pre-alarm
•
Low Oil Pressure Pre-alarm
• Low Fuel Level Pre-alarm
• Battery Overvoltage Pre-alarm
• Weak Battery Pre-alarm
•
Battery Charger Failure Pre-alarm
SPECIFICATIONS
RDP-110 Remote Display Panels have the following specifications.
Electrical
Power Input
DC Range 8 to 32 Vdc, 2 watts maximum
AC Range 84 to 144 Vac, 5 VA maximum
Hardware
Communication Port
Interface
RS-485 Used to communicate with DGC-2020, 500, 1000,
and 2000
Isolation 1800 Vdc for one minute between chassis
ground and ac voltage input. 700 Vdc for one
minute between any of the following groups
• Chassis ground
• Battery and 485 terminals
• AC voltage inputs
Radio Frequency Interference (RFI) Type tested using a 5 watt, hand-held
transceiver operating at random frequencies
centered around 144 and 440 megahertz with
the antenna located within 6 inches (15
centimeters) of the device in both vertical and
horizontal planes
Environment
Operating Temperature Range -40°C to 70°C (-40°F to 158°F)
Storage Temperature Range -40°C to 85°C (-40°F to 185°F)