Setting an ip qos policy, Specifying precedence for an ip qos policy, Configuring ipx qos policies – Cabletron Systems SmartSwitch User Manual
Page 287: Setting an ipx qos policy
SmartSwitch Router User Reference Manual
287
Chapter 19: QoS Configuration Guide
Setting an IP QoS Policy
To set a QoS policy on an IP traffic flow, enter the following command in Configure mode:
For example, the following command assigns control priority to any traffic coming from
the 10.10.11.0 network:
Specifying Precedence for an IP QoS Policy
To specify the precedence for an IP QoS policy, enter the following command in Configure
mode:
Configuring IPX QoS Policies
To configure an IPX QoS policy, perform the following tasks:
1.
Identify the Layer-3 or 4 flow, and set the IPX QoS policy.
2.
Specify the precedence for the fields within an IPX flow.
Setting an IPX QoS Policy
To set a QoS policy on an IPX traffic flow, enter the following command in Configure
mode:
Set an IP QoS policy.
qos set ip
<name>
<priority>
<srcaddr/mask>
|any
<dstaddr/mask>
|any
<srcport>
|any
<dstport>
|any
<tos>
|any
<port list>
|
<interface-list>
|any
<protocol>
|any
<tos-mask>|
any
<tos-precedence-
rewrite>|
any
<tos-rewrite>|
any
ssr(config)# qos set ip xyz control 10.10.11.0/24
Specify precedence for an
IP QoS policy.
qos precedence ip [sip
<num>
] [dip
<num>
]
[srcport
<num>
] [destport
<num>
]
[tos
<num>
] [protocol
<num>
] [intf
<num>
]
Set an IPX QoS policy.
qos set ipx
<name>
<priority>
<srcnet>
|any
<srcmask>
|any
<srcport>
|any
<dstnet>
|any
<dstmask>
|any
<dstport>
|any
<port list>
|
<interface-
list>
|any