Maintenance – Philips AZ1020-17 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MAINTENANCE
PRECAUTIONS AND SYSTEM MAINTENANCE
• Place the set on a hard, flat surface so that the system does
not tilt
• Do not expose the set, CDs, batteries or cassettes to humidity,
ram, sand or excessive heat caused by heating equipment or
direct sunlight
• Do not cover the set. Adequate ventilation with a minimum
gap of 15 cms between the ventilation holes and surrounding
surfaces is necessary to prevent heat build-up.
• The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
• To clean the set, use a soft, slightly dampened chamois
leather. Do not use any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may harm the
housing
CD player and CD handling
• The lens of the CD player should never be touched.
• Sudden changes in the surrounding temperature can cause
condensation to form and the lens of your CD player to cloud
over. Playing a CD is then not possible. Do not attempt to clean
the lens but leave the set in a warm environment until the
moisture evaporates,
• Use only Digital Audio CDs
• To take a CD out of its box, press the centre spindle while
lifting the CD. Always pick up the CD by the edge and replace
the CD back m its box after use to avoid scratching and dust.
• To clean the CD, wipe in a straight line from the centre
towards the edge using a soft, lint-free cloth Do not use
cleaning agents as they may damage the disc,
• Never write on a CD or attach stickers to it.
Tape deck maintenance
To ensure a good recording and playback of the tape deck, clean
parts
(
a j j
B )
and (C) show in the diagram below, after approx, 50
hours of operation, or on average once a month. Use a cotton bud
slightly moistened with alcohol or a special head cleaning fluid to
clean both decks.
/. Open the cassette holder by pressing STOP*OPEN
2.
Press PLAY ◄ and clean the rubber pressure rollers ©.
3.
Press PAUSE II and clean the magnetic heads (
a
) and also the
capstans ©
4. After cleaning, press STOP»OPEN BA.
Note:
Cleaning of the heads can also be done by playing a cleaning
cassette through once.
~Si
’
-
/>
{
i
:>
it’
11