Philips AZ1020-17 - Manual (Page 12)

TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair. If you are unable
to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Under no circumstances should you try to repair the set yourself, as this would
invalidate the guarantee.
PROBLEM
-
POSSIBLE CAUSE
• REMEDY
No sound/power
VOLUME is not adjusted.
• Adjust the VOLUME.
-
Headphones are connected.
• Disconnect headphones.
-
Mains lead not securely connected.
• Connect the AC mains lead properly.
-
Batteries exhausted.
• Insert fresh batteries.
-
Batteries incorrectly inserted.
• Insert the batteries correctly.
-
Batteries loaded but mains lead still plugged
in and connected
• Detach the mains plug from the MAINS
socket and the set
Poor radio reception___________________________
-
Weak radio signal
• FM: extend and aim the telescopic aerial for
best reception;
• MW IAM)/LW: rotate the set
CD playback does not work
-
CD is badly scratched or dirt,'.
• Replace or clean the CD, see Mainterrance.
-
Laser lens steamed up.
• Wait until lens has acclimatized.
The CD skips tracks____________________________
-
CD is damaged or dirti'.
• Replace or clean the CD.
-
SHUFFLE or PROGRAM is active.
• Quit SHUFFLE/PROGRAM mode(s).
Poor cassette sound quality___________________
-
Dust and dirt on the heads, etc.
• Clean deck parts etc., see maintenance.
-
Use of incompatible cassette types (METAL
or CHROME).
• Only use NORMAL (lEC I) for recording.
Recording does not work
-
Cassette tab(s] may be broken out.
• Apply a piece of adhesive tape over the
missing tab space.
This set complies with the radio interference requirements of the European Union.
The type plate is located on the bottom of the set
12