Compaq XL280 User Manual

Page 60

Advertising
background image

24 T

ROUBLESHOOTING

P

RESARIO

N

OTEBOOK

M

AINTENANCE

AND

S

ERVICE

G

UIDE

1800 S

ERIES

Presario 1800/1800T Series

Models: XL280, XL380, XL381,

and XL390

**The backlight or its power circuitry has failed. If the backlight is not functioning, the POST

result cannot be observed. Connect the unit to an external monitor before restarting the

unit. If an external monitor is not available verify that POST is complete by opening and

closing the display, listening for the single or double beep, and watching for the icons to

turn on at the front of the Notebook.

Display has overheated.

Turn off the Notebook, and if

necessary move it out of direct

sunlight to allow it to cool.

Display is blank and
the Standby

é

icon is

flashing.

System is in Standby mode.

Press any key or touch the
TouchPad.

Notebook display is

blank and the screen

on an external monitor

displays information.

Display function was switched

to the external monitor.

Press Fn+F3 to switch between

the external monitor and the

Notebook display (you may have

to press more than once).

Notebook display

flashes or has garbled

characters when

Notebook is connected

to external monitor.

The external monitor is set for

1024 x 768 or higher

resolution and view is toggled

back to the Notebook display,

which supports up to

800 x 600.

Restart the Notebook.

The light tubes on the

edge of the display

panel do not light up at

all and the Power-On

Self-Test (POST)

completes on

startup.**

Improper backlight or display

cable connections.

1. Check the display cable

connections and retest.

2.

Replace the display assembly

.

Defective inverter board.

Replace the display assembly

.

Defective display cable.

Replace the display assembly

.

Defective display panel.

Replace the display assembly

.

Defective system board.

Replace the system board

.

The light tubes on the

edge of the display

panel do not light up at

all and the Power-On

Self-Test does not

complete on startup.**

Defective system board.

Replace the system board

.

Display

Problem

Probable Cause

Solution(s)

Advertising