Install the ptotectot system, Facing the door from inside the garage, Install the protector system® -22 – Craftsman 1/2 HP GARAGE DOOR OPENER MODEL 139.5364812 User Manual

Page 20: Warning

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Install The Ptotectot System®

The safety reversing sensor must be connected
and aligned correctly before the garage door
opener will move in the down direction.

IMPORTANT INFORMATION ABOUT
THE SAFETY REVERSING SENSOR

When properly connected and aligned, the sensor
will detect an obstacle in the path of its electronic
beam. The sending eye (with an green indicator light)
transmits an invisible light beam to the receiving eye
(with a green indicator light). If an obstruction breaks
the light beam while the door is closing, the door will
stop and reverse to full open position, and the
opener lights will flash 10 times.

The units must be installed inside the garage so that
the sending and receiving eyes face each other
across the door, no more than 6" (15 cm) above the
floor. Either can be installed on the left or right of the
door as long as the sun never shines directly into the
receiving eye lens.

The mounting brackets are designed to clip onto the
track of sectional garage doors without additional
hardware.

INSTALLATION STEP 10

WARNING

Be sure power is not connected to the garage door
opener BEFORE installing the safety reversing sensor.

To prevent SERIOUS INJURY or DEATH from a closing
garage door:
• Correctly connect and align the safety reversing

sensor. This required safety device MUST NOT be

disabled.

• Install the safety reversing sensor so beam is NO

HIGHER than 6" (15 cm) above garage floor.

If it is necessary to mount the units on the wall, the
brackets must be securely fastened to a solid

surface such as the wall framing. Extension brackets
(see accessories) are available if needed. If
installing in masonry construction, add a piece of
wood at each location to avoid drilling extra holes in
masonry if repositioning is necessary.

The invisible light beam path must be unobstructed.

No part of the garage door (or door tracks, springs,
hinges, rollers or other hardware) may interrupt the
beam while the door is closing.

Facing the door from inside the garage

20

Advertising