Select the setup menu, Highlight vcrl channel, Diagram used from the connection guide – Sears 274.4372859 User Manual
Page 11: Set vcr 1 channel to, Using your tv and remote, With vcrs: setting the vcr 1 channel
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
With VCRs: Setting the VCR 1 Channel
The VCR 1 Channel works with the
VCR1
button on the remote. If the
VCR 1 Channel is set, pressing
VCR
selects the channel to see the VCR
picture. The VCR 1 Channel setting depends on which diagram you have
used from the Connection Guide. If you want to turn this feature off, set
the VCR 1 Channel to Disable.
Refer to the chart below for your setting.
Using Your TV and Remote
1. Select the Setup Menu
13
Controls Alarm Adjust Pet
BuloBi
Label: 13
Clear
Channel Memory: 13 Stored
Cable/Air: Cable
VCR 1 Channel: 03
A. Press TV to set the remote to
control the TV.
B. Press MENU»PROG to select the
Setup menu. This menu is
white.
2. Highlight VCRl Channel
13
Controls Alarm Adjust Setup
Aii’nprogram
Label: 13
Clear
Channel Memory: 13 Stored
Cable'Air' Cable ___________
VCR 1 Channel: 03
A. Press MOVE
T
to highlight the
VCR 1 Channel.
B. Press MOVE ► to highlight the
channel.
3. Enter channel number
13
Controls Alarm Adjust Setup
Autoprogram
Label: 13
Clear
Channel Memory; 13 Stored
Cable.'Air: Cable
Enter channel 00, 03, or 04. Choose
your setting from the chart below.
Press MOVE
T
until "Disabled" is
displayed to turn the feature off.
Diagram used from the
Connection Guide:
IB, 1C, 2B, 2C, 3B, 3C, 4C, 5C
4B, 5B
....'"■'"V.
Set VCR 1 Channel to:
00
3 or 4 (same as 3/4 switch)
......... ;