Sears 274.4372859 - Manual (Page 29)

References
Trouble Checks
You may have problems that can be fixed with a tew minor adjustments.
Look for the type of problem you are having below and then try the
suggestions to get your TV going again.
Trouble Checks and Adjustments
Power
TV will not turn on Plug TV in.
Plug something else into the outlet to make sure it is working.
Make sure batteries in the remote are not dead.
Aim the remote at the TV and press TV.
Make sure batteries are placed in the remote the right way. See batterieb
on page 2.
Unplug TV for a few minutes and then turn it on again.
No picture, no sound but
TV has power Check antenna connections.
Check position of Cable/Air feature. See page 24.
Try another channel. Inactive channel may be tuned.
Make sure component connected to the VIDEO INPUT jacks is turned on
if you choose channel 00.
Make sure TV is tuned to the same channel as the switch on back of VCR
if watching a VCR.
Make sure TV/VCR button on VCR is in correct position when using VCR.
Remote
Buttons don't work when
you press them Press TV to set the remote to control the TV. See buttons on page 6-7.
Works part or none of the
time Clear the path between the remote and TV of any objects.
Aim the remote at the component you are trying to control.
Press TV so remote will control TV.
Make sure batteries in the remote are not dead.
See if batteries are placed in remote correctly. See batteries, page 2.
Can't select certain channel Press number buttons. Channel may not be in memory. See Autoprogram
on page 19.
Make sure TV/VCR switch on VCR is in the TV position.
For numbers over 100, press
and hold
1
until
1—
appears, then press the
Other two numbers.
Set Cable/Air feature to Cable for channels higher than 69. See page 24.
Remote Lockup
Remove batteries and hold down one or more buttons for several seconds
to drain the microprocessor inside the remote and reset it. Re-install the
batteries and try remote again.
27