Sears 758.144131 - Manual (Page 8)

Using Your Humidifier.
>tep 1
3e sure humidifier is fuil of water and
ilugged in.
Step 2
Set Speed Control to 1.
Step 3
Set Humidity Control to a medium
position (half way between MIN and
MAX).
NOTE: Humidifier should operate with
humidity control on the recommended
medium setting. If it does not, the humidity
is at a relativeiy high level. To test the unit
under this condition, turn Humidity Control
all the way to MAX and unit should begin to
operate. After the unit has been tested, set
Humidity
Control to medium or desired
level.
Allow 24 hours for humidifier to adjust.
If humidity level in home is sufficient, the
humidifier will only operate with Humidity
Control set on MAX.
IMPORTANT: Water damage may result if
condensation starts to form on windows or
walls. Humidity Control setting should be
lowered until condensation no longer
forms.
Step 4
If humidifier stops running and the Fill Light
is not illuminated, the humidity level is at
the normai requirements for that setting or
it is adjusting to the home conditions. The
table below shows recommended indoor
humidity levels. The figure below shows
approximate
relative humidity percentages
which correspond to the various settings of
the Humidity Control.
When Outdoor
Temperature is:
Recommended
Indoor Relative
Humidity is:
-tO-F 20%
0°F 25%
10°F 30%
20°F & above 35%
sovsoK
Relative Humidity
Operating Tips for Best Performance
1. Position the humidifier at least 2 inches
from any wall and away from any heal
registers.
2. Do not restrict airflow from entering or
exiting the humidifier.
3. Use Sears recommended bacteriostat
42-14900 to retard bacteria growth that
may cause odors and may be harmful
to your health.
4. Perform regular cleaning as instructed
in “Cleaning Your Humidifier” section of
this manual.
5. Replace the evaporative wicking filters
at least once per humidification season
or more depending on water conditions
in your area.