Canon SCANFRONT 220 - Manual (Page 33)

3-2
Chapter 3 ScanFront Setup
1.
Before Setting Up the Scanner
Before setting up the scanner, you need to move it to the installation site, and connect the AC adaptor and network cable.
❏ Installation Location
The performance of this scanner is affected by the
environment in which it is installed. Make sure that the
location where the scanner is installed meets the following
environmental requirements.
● Provide adequate space around the scanner for
operation, maintenance, and ventilation.
● Avoid installing the machine in direct sunlight. If
this is unavoidable, use curtains to shade the
scanner.
● Avoid locations where a considerable amount of
dust accumulates.
● Avoid warm or humid locations, such as in the
vicinity of a water faucet, water heater, or
humidifier, and avoid locations where the fumes
from ammonia, paint thinner, or other volatile
chemicals may be present.
● Avoid locations that are subject to vibration.
● Avoid exposing the scanner to rapid changes in
temperature. If the room in which the scanner is
installed is cold but rapidly heated, water droplets
(condensation) may form inside the scanner. This
may result in a noticeable degradation in scanning
quality.
The following conditions are recommended for
optimal scanning quality:
Room temperature: 10 °C to 32.5 °C (50 °F to
90.5 °F)
Humidity: 20% to 80% RH
● Avoid installing the scanner near equipment that
generates a magnetic field (e.g. speakers,
televisions, or radios).
❏ Interfaces
The interfaces are located on the right side of the scanner.
a Power Connector: Connect the plug of the
supplied AC adapter.
b LAN Port: Connect a network cable designed for
use with an RJ-45 modular jack.
c PS/2 Connector (Green): Connect a PS/2 mouse.
d PS/2 Connector (Purple): Connect a PS/2
keyboard.
e USB Ports: Connect a USB memory device, USB
keyboard, or USB mouse.
At least
400 mm
At least
600 mm