Sears 358.357182 - Manual (Page 19)

о.
ЖТА1ГГвЙ Й01»Б
• Я«р1«а1 « starter гор« that braaics.
AVIARNtNG
Atwaysweareyeprotectlen whan sarvic«
1 п 9 the stanar rope. Hi« recoil spring
b«n«ath the pulfey is under tension, if the
[spring pops out, serious injury -can
NOTE: Therecorisprmg, iocated beneath the pulley,
isundertension, if springpepsout.it will require
considerable time and effort to retnstail. fcrthis
reason, you may warn
to let your Seats Service
CentertDepartinenthandlelhörep^lf youdotryio
repair ptestanerrope and №e reoc^ spring popsout,
tafce the saw öj your Seats Зеглсе Center/
DepartmenL
1 Dram thefuei tank.
2. Remove the fan housing screw on the bottom of the
saw and we two screwson wesstetfthe fan housmg.
3. Remove the large screw at the rear of the
Control handle ana the small screw directly
betevsf it. Pigare3S.
4. Separate the fan housing from me engine.
5. If starter rope is rtot broken, release the spring
tension by pulling abouttO inches of rope from the
pulley and catch me rope m the notch as shown.
Figure 40. Turn the pulley coumerctock-
wise until the spnmj tension is released
NOTE; The tension on We starter spring wiH be
released it the rooe is broken.
& RemovescrewandpuUeyvefycard^iy.Rgure4l.
The reçoit spring wMeh lies beneath the pulley
must stay in Ше housing, ftat against the bot-
tom.lf1hespringist^KuttMid,itw9requirecotv-
siderabie lime and effort to reinstall, iwtst the
l%iileygentty counterclockwise as you pull up to
release the spring.
7. yoosenreiainirig screw arxfrenioreoid rope. Figure
8. Move away from №c fuel tank with the rope to be
installed. Use a match and melt boW ends of t he rope
to prevent fraying.
3, RuUfhemeitedendsthrou^athid(.£leanragwhile
the rope is s^i trot to otem smoom. pointed ups.
Insert one end erf the rope through the handle and
secure with a knot. Leave ЗП6' pigtail behind knot
Figure 40 {inset).
Insert the free end of the rope mrough the rope exit
hole two the msate of the fan housing.
Guide rope mside puOey, then through the
pulley hole lo the outside by pushing me rope
through from the holeonthespraigcamside with
a small Phillips sciewdrivei: f igtee 41 (insec).
УУ»эд rope ooumercioekiinse around puUey
radwandtucOtlooeeendbadtunderrope leaving
a 1 inctita^ betvwMnthertfainerfi) and S 08 W
post. Tighten retaining screw. Figur« 4i.
NGiTE: Oo not omtigham the icp* retaining screw
Overtigfaoning the screw can еацш the screw
poaro strip out Ughten the screw until the bcdpm
of the washer is snug against the rape.
14. Wind all but about 10 inches of »e rope dock-
wise around me puney.
to.
It.
12
13.
REMOVE
FAN HOUSING
SCREWS
Figure 38
REMOVE CONTROt
HANDLE SCREWS
SCREW
F i £^39