Amana RAYTHEON LE2502 - Manual (Page 9)

TO INSTALL DRYING RACKS
1. Open dryer loading door.
2. Place rack inside dryer cylinder, resting front legs of rack on loading
door opening.
3. Lower back of rack until rack rests above the two projections located in
the rear of the dryer cylinder.
NOTE: Rack doesn't have to be level from front to back when installed
in dryer.
CAUTION
Tlie back of the rack must rest above the two projections at the back of the
dryer cylirxjer. The inside of the dryer and rack can be damaged if the back of
the rack is installed below the projections. Don't let items hang below or over
the sides of the rack. Never tumble items while rack is inside the dryer.
After articles have been dried, remove rack from inside of dryer cylinder.
HELPS AND HINTS
A WARNING - To reduce the risk of fire, clothes which have traces
of any flammable substances such as cooking oil, machine oil,
flammable chemicals, thinner, etc. must not be put into the dryer.
REGULAR OR * UNTREATED CLOTHES
A properly sorted wash load is generally a dryer load. In both washing and
drying, the bulk or volume of clothes, rather than pounds, will determine the
load size. The dryer cylinder is large and is designed to dry a large or average
load at maximum efficiency.
DO NOT OVERLOAD THE DRYER - MAXIMUM LOAD: Dryer cylinder one half
full of wet clothes.
Loads consisting of several small pieces only such as knit shorts or diapers do not
tumble well and may require longer drying time which could result in excessive
wrinkling. Add several towels to aid tumbling. Large and small items together
make the best load for the dryer.
-14-