Hunter Angled Ceiling Mount Adapters - Manual

S I N C E 18 8 5
READ AND SAVE THESE INSTRUCTIONS
ANGLE CEILING MOUNTING ANGLE BEAM MOUNTING
CUT 4".ROUND
HOLE IN CEILING
CEILING BEAM
CLEVIS PIN
DRILL Hote NO LARGER THAN MINOR
DIAMETER OF LAG BOLT (.371*) 2* DEEP
BEAM (SEE NOTE 1)
4* X nV WIRING
BOX (NOT
SUPPLIED)
4“ ROUND WIRING
BOX (NOT SUPPLIED)
NAIL TO BEAM
TW-'O PLACES
HANGER BRACKET
WITH RUBBER BUSHINGS
X 2’/i* LAG BOLT
(SEE NOTE 2) •
NAIL TO BEAM
TWO PLACES
SOCKET WRENCH
(SEE NOTE 3)
HANGER BRACKET WITH
RUBBER BUSHINGS
X 2W LAG BOLT
(SEE NOTE 2)
y/ PIPE STEM
CEILING FAN
install BUSHINGS IN
TWO HOLES IN PIPE END
BEFORE HANGING FAN.
V(6* DIA. HOLES CENTERED
VV FROM END OF PIPE
Installation Notes:
1. Hplc in beam must be straight to properly
scat V/' lag bolt.
2. Do not use lubricant on screw threads.
3. A socket wrench or box end wrench is
essential to install lag bolt.
SOCKET WRENCH
(SEE NOTE 3)
WOOD BEAM,
FLAT WASHERS
CLEVIS PIN
COTTER PIN
CANOPY
EXTENSION RING
CANOPY
CANOPY SCREW
y PIPE STEM
CEILING FAN
FORM NO. 41220-01 5/95 - 1 - 01995 HUNTER F A N C