Hunter 25271 Globe Fitter - Manual

SINCK ^806
INSTALLATION INSTRUCTIONS FOR
HUNTER CEILING FAN LIGHT KIT #27196, #27220, #27216, #27217, #27218 & #27219
ENERGY EFFICIENT FLUORESCENT LOW PROFILE'FAN LIGHT
READ AND SAVE THESE INSTRUCTIONS
A. CAUTION:
1. TO REDUCE THE RISK OF FIRE AND ELECTRICAL SHOCK, INSTALL THIS LIGHT KIT ONLY ON LISTED
HUNTER CEILING FANS TYPE A THRU Z.
2. READ ENTIRE INSTRUCTIONS CAREFULLY BEFORE BEGINNING INSTALLATION.
3. TO AVOID POSSIBLE ELECTRICAL SHOCK, BE CERTAIN ELECTRICITY IS TURNED OFF AT FUSE OR
CIRCUIT BREAKER PANEL BEFORE WIRING.
4. ALL WIRING MUST BE IN ACCORDANCE WITH NATIONAL AND LOCAL ELECTRICAL COOES. IF YOU ARE
UNFAMILIAR WITH WIRING, YOU SHOULD USE A QUALIFIED ELECTRICIAN.
B. CONNECT WIRES TO FAN:
K|p,-rr. * SEE FAN INST/^LLATION INSTRUCTIONS FOR CONNECTING HOUSE WIRING TO THE FAN.
» CONNECT HOUSE WIRING TO THE FAN BEFORE ATTACHING THE LIGHT KIT TO THE FAN,
» SEE WIRING DIAGRAMS ON REVERSE SIDE FOR LIGHT KIT USE WITH WALL SWITCHES,
1. REMOVE THE COVER PLATE FROM THE BOTTOM OF THE FAN SWITCH HOUSING. REMOVE THE LIGHT KIT
COVER PLATE FROM THE LIGHT KIT. SEE FIG. 1. IF THE COYER PLATE FROM THE SWITCH HOUSING
HAS A HOLE IN THE CENTER, PROCEED TO STEP 2B. IF THE COVER PLATE DOES NOT HAVE A HOLE
IN THE CENTER, DISCARD THE COVER AND PROCEED TO STEP 2A.
2A. LOCATE THE TWO WIRES IN THE FAN SWITCH HOUSING THAT- HAVE LABELS MARKED "CONNECT LIGHT
HERE" OR "FOR LIGHT USE". ONE WIRE WILL BE WHITE AND THE SECOND WILL BE BLACK WITH A
WHITE TRACER. CONNECT THESE WIRES TO THE WIRES COMING FROM THE LIGHT KIT, CONNECTING
WHITE TO WHITE AND BLACK WITH WHITE TRACER TO BLACK WIRE. FROM LIGHT KIT. ASSEMBLE THE LIGHT
K it TO THE fan using the - mounting screws removed in step 1 ABOVE. SEE FIGURE 1.
THEN PROCEED TO STEP 3.
2B, ASSEMBLE THE FAN COVER PLATE TO THE LIGHT KIT AS SHOWN IN FIGURE 2. USE THE PIPE NIPPLE AND
NUTS PROVIDED. THEN FOLLOW THE DIRECTIONS IN STEP 2A ABOVE TO ATTACH LIGHT KIT TO FAN.
C. FINAL STEPS
3. INSTALL ONE 22 WATT CIRCLINE FLOURESCENT BULB
4. HAND TIGHTEN ALL THUMB SCREWS SECURELY. SEE FIG. 2. RESTORE POWER TO
FAN TO complete INSTALLATION.
5. SHOULD LIGHT SHADE BEGIN TO BUZZ. BE CERTAIN ALL THUMBSCEWS ARE TIGHT
FORM 41371-01 REV 2/98