Maikknihce, To replace oven light bulb, Oveidiioii – Maytag ACCELLIS MER67 User Manual

Page 14: Ovthyilhdow itvtllhg lt6s oybuighis, Storage dra№r, Cohvlnithct outltt

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

MAIKKNIHCE

oveiDiioii

Do not place excessive weight on or
stand on an open oven door. This
could cause the range to tip over,

break the door, or injure the user.

When opening the oven door, allow

steam and hot air to escape before

reaching in oven to check, add or
remove food. This is especially im­
portant when using the Speed Op­
tions feature as you may notice more

moisture in oven with speed cooking.

The oven door can only be removed

by an authorized servicer. Do not

attempt to remove the door yourself.

OVtHyilHDOW

ItVtllHG Lt6S

OYBUIGHIS

To assure the proper replacement bulb
is usedf order bulb from Maytag Cus­
tomer Service, Cali 1-800-688-8408, ask

for part number 74004458-halogen bulb.

To protect the oven door window:

1. Do not hit the glass with pots, pans, furni­

ture, toys, or other objects.

2.

Do not close the oven door until the oven

racks are in place.

Scratching, hitting, jarring or stressing the glass

may weaken its structure causing an increased
risk of breakage at a later date.

»- Disconnect power to range before

replacing light bulb.

Allow oven, bulb cover and bulb to
cool before touching.

Do not remove aluminum washer
from bulb cover when replacing the

bulb.

- Be sure the anti-tip bracket

secures one of the rear lev­

eling legs to the floor.

This bracket

prevents the

range from ac-
cidentallytipping.

The range should be leveled when installed.

If the range is not level, turn the plastic
leveling legs, located at each corner of the
range, until range is level.

To replace oven light bulb;

There are two halogen light bulbs located

at the front corners of the oven cavity.

1. When oven is cool, turn bulb cover to

remove.

2. Carefully remove old bulb by pulling

straight out of ceramic base.

3. To avoid damaging or decreasing the

life of the new bulb, do not touch the
bulb with bare hands or fingers. Hold
with a cloth or paper towel. Push new

bulb prongs straight into small holes of
ceramic base.

4. Replace bulb cover by turning until tight,

5. Reconnect power to the range. Reset

clock.

STORAGE DRA№R

The storage drawer at the bottom of me

range is safe and convenient for storing

metal and glass cookware. DO NOT store
plastic, paperware, food or flammable

material in this drawer. Remove drawer to
clean under range.

To remove; Empty drawer then pull out to

the first stop position. Lift up front of

drawer and pull to the second stop posi­
tion. Grasp sides and lift up and out to

remove drawer.

To replace; Fit the ends of the drawer

glides onto the rails. Lift up drawer front

and gently push in to first stop position.
Lift up and continue to slide drawer to the
closed position.

COHVlNItHCt OUTltT

(C

anadian

models

only

)

The convenience outlet is located on the

lower left side of the backguard.

Be sure appliance cords do not rest on or
near the surface element. If the surface
element is turned on, the cord and outlet
will be damaged.

The convenience outlet circuit breaker

may trip if the small appliance plugged
into it exceeds 10 amps. To reset the
circuit breaker, press the switch located

on the lower edge of the backguard.

CIRCUIT BREAKER SWITCH

li

Advertising