Maytag 53-3442 User Manual
Automatic dryer, Installation instructions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION INSTRUCTIONS
AUTOMATIC DRYER
PLEASE READ ALL INSTALLATION
INSTRUCTIONS AND REQUIREMENTS
BEFORE INSTALLING
A WARNING
FOR YOUR SAFETY
Do not store or use gasoline or other
flammable vapors or liquids in the
vicinity of this or any other appliance.
-TOOLS REQUIRED-
V
DEEP WELL DRIVER
V;’ DRIVER
CHANNEL LOCK PLIERS
OR ADJUSTABLE WRENCH
SCREWDRIVER
(BLADE & TORX)
PUTTY KNIFE DUCT TAPE
INSTALLING YOUR NEW DRYER
FOR YOUR SAFETY AND THE PROPER OPERA
TION OF YOUR NEW DRYER, THE DRYER
MUST BE INSTALLED IN ACCORDANCE WITH
ALL THE INSTALLATION REQUIREMENTS.
All literature should be removed from inside dryer and
saved for future reference.
NOTE; DO NOT RAISE OR LOWER THE DRYER BY
THE BACKGUARD.
1. To remove the corrugated crate base, place your
foot on the base close to a leveling foot. Pushing
down firmly with your foot, tilt the dryer away from
you.
2. Repeat process with all leveling feet (4). Remove
excess base by hand.
P/N 53-3442
BACKGUARD
Document Outline
- A WARNING
- FOR YOUR SAFETY
- PLe/^SE read All Installation Instructions and Requirements Before Installing Power Cord.
- LOCATION
- DO NOT INSTALL THE DRYER ON A CARPETED FLOOR.
- THE INSTALLATION MUST BE MADE WITH ADEQUATE CLEARANCE TO PERMIT SERVICING.
- ELECTRICAL REQUIREMENTS
- GROUNDING INSTRUCTIONS
- NOTE; DO NOT REMOVE THE INTERNAL GROUND WIRE
- OR BRASS STRAP EXCEPT WHERE INSTRUCTED AND
- REQUIRED BY LOCAL CODES AND ORDINANCES OF
- YOUR AREA.
- TYPICAL ELECTRICAL CONNECTIONS
- 3-WIRE SYSTEM WITH GROUNDED NEUTRAL -
- 2. STABILITY
- 3A. OUTSIDE WALL
- 3B. BASEMENT WALL
- 3C. FLOOR EXHAUSTING
- 4. ELECTRICAL CONNECTION
- FIG. #4-
- BOTTOM EXHAUSTING
- SPECIAL REQUIREMENTS FOR MANUFACTURED
- (MOBILE) HOME INSTALLATIONS