Iv. bios setup – Asus P/I-P6RP4 User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
IV. BIOS SETUP
Ailvart0#<i Se'tup
PrinAry Slave I PE Pi О M
o
J
p
Ppinarv ГРЕ
1
eir*
rrlnary
Master
ЬВЙ
MvJ#
Pk'lMairy
Slave
lt-ВЯ
Mode
ScevoJaic'y Ctrl BirivtE Precent
: ^u±a
Hi safat ed
HI £ яЫ ad
Ht s аЫ ed
Moo»
Primary IDE 32Bit Transfer
Origina] JDE cards are
I
Gbit and thcrcftnrc will not fitnelion properly using
32bit transfer* 32bit iransfers are only available in enhanced IDE cards.
The serting-S are: Disabie or ЕпаЫе.
Primary Master LB A Mode
Set this option to enabled to enable IDE LBA (Logic Block Address) Mode
for the first IDE drive attached to
The
primary IDE channel. LBA Mode is
an advanced metJtod for accessing data un IDE drives* Data i$ accessed by
block address rather than thetradiiional Cylirtder-Head-Eectorschcnne. Data
transfer rates can be much higjter in LBA inode* Either/Juiifrfp tv £^гпй/е.
Primary Slave LBA Mode
Same aE the previous but for the slave. The settings are: Dtsablii or Enahie.
Secondary Ctri Drives Present
This option specifies the number of IDE drives controlled by the chipset for
the secondary IDE channel.
The settings are:
i^one, i, or 2.
Secondary Ctrl Drives Present
Secondary Sieve IDE PtO Mode
Secondary iDE 32Bit Transfer
Secondary Master LBA Mode
Secondary Slave LBA Mode
The above five sdecUonsi only appear when the Secondary Ctrl Drives are
set to I (except Slave) or 1. The settings are the same as the Master selec
tions but refer to ihe IDE drives connected a second ribbon cable connected
(n (he secondary IDE connccti[>n on the mcnherbourd.