On board pa tde, Boot to pnp operating system, Pci foe card present in – Asus P/I-P6RP4 User Manual
Page 29: Pci !de irq connected to, Sfot 7 /rq sefect siot z.„ sfoi 3.,., s/of 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
î,3 Chipset Setup
Cliipçtt
Oi> Bail'd PCI lUF
Boot to PnP OPerik^inS syptt
PCI IPE C*Pd Present i
Slotl L RO Seiecit
Slot^
I
Select
Slots
IRQ
Select
5]at4 IRQ Select
Enabled
No
Bbserht
ñuto
ñuto
ñuto
ñuto
U
On Board pa tDE
This aîlows The user cn disable the on-board TDt
sû
UiaL
an ejitenial IDE
contra!
1er
can
be
used. I'Jie settings
Etre;
Di^abiedor Enttbied
Boot to PnP operating system
Disabling this hmctlon prevents the BIOS (0 auioniaucallv assign an IRQ
[штЬЕГ to the Plug and Play (PnP) cards.
The
settings ate;
So or
i'ti
PCi fOE Card Present in
it'using an external PCI IDE contmiier caid. you must tell the computer
where the card is located so that your drives can bool*up properly. The
settings are; Absein. /. Sht 2. or^iai J.
PCI !DE iRQ Connected to
Only active when Ше previous is set to a specific slot number. This allows
tlie user to select
the
Iniemipt assignment for the
PCI
card. Most cards use
ÎNTA
but
if
ftecessaiy you may choose
!NTB. fNTC, iSJD.
Sfot 7 /RQ Sefect Siot Z.„ Sfoi 3.,., S/of 4.,,
Slot I, 2, 3, and 4 refers to lire PC! Slots I through^. An IRQ number is
automatically assigned but if necessary you can manually change the a.s-
signmcni
(¡RO S.
4
.
i, 7, P, ¡0, !l.
¡
2
,
}4^ /J) to fit any software or hard
ware requirements,
The
defaults are al I set to
лша.