Troy-Bilt GTX 20 - Manual (Page 26)

Storage
Storing the Tractor
Always store tractor in a dry and protected place when not in use to protect it from the elements. When tractor is used year round, it
is not necessary to store tractor. If tractor will not be used for a season, store it in the following manner.
□ Cleaning
Completely clean all accumulated dirt
or grass from all parts - especially
engine fins, hydrostatic fins and
flywheel screen.
□ Protecting Finish
Wipe oil or a rust preventative on any
parts which may rust. Touch up any
area where paint has been chipped or
worn off on the tractor.
□ Gas Tank
Drain gas tank and carburetor.
□ Changing Oil
Change engine oil while engine is still
hot (see "Engine Oil", page 20).
□ Fuei Filter and Air Cleaner
Check fuel filter and air cleaner.
Replace if dirty or damaged. (See
"Air Cleaner", page 20).
□ Sparkplug
Remove, clean and re-gap spark
plug. Place a small amount of oil
(SAE 30) into cylinder. Turn engine
over a few times to fully lubricate the
cylinder walls, valve seats and valve
stems. This can be performed by
engaging the key starter briefly.
Replace spark plug. (See "Spark
Plugs", page 22).
□ Battery
Check battery. Keep terminal posts
cleaned of corrosion salts. Coat
terminal posts with petroleum jelly or
grease. Keep cables clean. A stored
battery must be kept fully charged
with ali cells filled. Store at a cool
temperature - 20° F to 50° F. Check
every two months and charge as
necessary.
□ Lowering Attachment
If tractor is stored with an attachment
mounted on it, lower the attachment
to the ground. Turn PTO/attachment
drive switch to "OFF".
□ Protecting from Elements
During the winter, store the tractor
inside a building. If this is not
possible, protect the tractor from
snow and ice with a waterproof tarp
or cover.
□ PTO Clutch
After storage, operate the PTO clutch
10 to 15 times, at idle, before
operation.
26