Controls and features, Electric starter, Throwing snow – Ariens SNO-THRO 008-SS322E User Manual
Page 17: Controls and features throwing snow, Electric start option
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1. Switch Box
2. Starter Button
3. Female End of Power Cord
Figure 11
C
ontrols
and
F
eatures
Electric Starter
Optional on models 938006, 007, 301,303 (Figure 11).
IMPORTANT:
Electric starter is not equipped with a
thermal cutout switch. DO NOT crank engine for more
than 20 seconds. Always allow electric starter to cool
down for 10 minutes or electric starter damage will
result.
1. Follow Starting and Shut Off steps 1 -5.
2. Connect female end of power cord to Switch Box.
3. Plug male end of power cord into 120 volt AC
receptacle.
4. Push Starter Button to crank engine.
5. When engine starts, release Starter Button and
, disconnect Power Cord from receptacle first, then
from Switch Box.
6. Gradually push in choke control knob to housing.
T
hrowing
S
now
Lift the Handlebar only high enough to propel unit
forward. Do not lift so high to allow snow to kick back
from under unit.
To clear an area, run unit in an overlapping
series of paths. For large areas start in
middle and throw snow to each side so you
do not have to move snow more than once.
ALWAYS direct snow away from area to be
cleared and with direction of wind.
Ariens* Sno-Thro* Orig. 4/96
13