Mr. Coffee 115949 - Manual (Page 17)

8. Fill the water reservoir with clean, fresh water.
9. Place the empty decanter back on the coffeemaker, centered on the warmer plate.
10. Remove and discard the filter used during the cleaning cycle and replace it with a fresh
MR. COFFEE® 10-12 cup basket-style paper filter. If a MR. COFFEE® permanent filter was
used during cleaning, remove it and rinse it thoroughly before replacing it in the filter
basket.
11. Begin brewing and allow the full brew cycle to complete.
12. Repeat Steps 8 through 11 one more time.
Your coffeemaker is now clean and ready to brew the next pot of delicious, hot coffee!
For Programmable models (ISX20/ISX23/ISX26 and ISTX85):
Follow steps 1-3 above. Press the SELECT button until the red CLEAN indicator light is
illuminated. For your convenience the cleaning cycle is automatic. The entire cycle will
take 45-60 minutes to complete. During the cleaning your coffeemaker will;
1. Slow brew approx. 3 cups of cleaning solution.
2. Pause for 30 minutes (the CLEAN light will remain on to alert you that the process is
active). At the end of the pause period your coffeemaker will beep.
3. After 30 minutes, your coffeemaker will brew the remainder of the cleaning solution.
4. When complete, the CLEAN light will turn off and your coffeemaker will automatically
beep and shut off. Follow Steps 7-12 above to thoroughly rinse out the coffeemaker.
Suggested Decalcifying Intervai
Type of Water_______ Cleaning Frequency
Soft Water Every 80 Brew Cycles
Hard Water Every 40 Brew Cycles
or when red light is flashing (programmable models).
©