MTD 216-320-000 - Manual (Page 12)

CARBURETOR ADJUSTMENT
AC
WARNING
If any adjustments are made to the
engine while the engine is running
(e.g.
carburetor), disengage all
clutches and tines. Keep clear of all
moving parts and be careful of
heated surfaces and muffler.
Never make unnecessary adjustments. The actory
recommended settings are correct for most appli­
cations.
If adjustments are needed, refer to the engine manual
packed with the tiller.
LUBRICATION
CHAIN CASE
The chain case is pre-lubricated and sealed at the fac­
tory. It requires no checking unless the chain case is
disassembled. To fill with grease, lay the left hall of the
chain case on its side, add 12 ounces of Plastiliibe #0
grease and assemble the right half to it. This grease
can be obtained at your nearest authorized deale listed
on the back of this manual. Order Part N jmber
737-0133.
To change oil, remove drain plug and tip the tiller for­
ward while engine is warm. See figure 22. Replace
drain plug. Remove oil filler cap and refill with new oil
of proper grade. Replace filler cap.
AIR CLEANER
The air cleaner prevents damaging dirt, dust, etc., from
entering the carburetor and being forced into the engine
and is important to engine life and performance.
To service air cleaner, refer to the engine manual
packed with the tiller.
Never run your engine without air cleaner com­
pletely assembled.
CLEAN ENGINE
Wipe off all spilled fuel and oil. Keep the engine clean
of foreign matter and be sure the cooling fins on the
cylinder are kept clean to permit proper air circulation.
This is an air-cooled engine and free flow of air is essen­
tial to proper engine performance and life.
SPARK PLUG
The spark plug should be cleaned and the gap reset
at least once a season or when oil is changed. Spark
plug replacement is recommended at the start of each
season; check engine manual for correct plug type and
gap specification.
MAINTENANCE
ENGINE OIL
Check the oil level in the crankcase before each use.
Change the oil in the crankcase after the first twc hours
of operation of your new engine and after each 2T hours
of use thereafter to insure proper lubrication of inter­
nal parts. (Take care to remove dirt around fillei plug.)
Be sure oil level is maintained full to point of ov 3rflow-
ing. See figure 22.
BELT REPLACEMENT
If belt replacement is required, order belt or belts by
part number from your nearest authorized dealer.
1. Remove the belt cover by removing three self­
tapping screws. A 3/8" wrench is required. See
figure 23.
12