MTD 216-320-000 - Manual (Page 5)

Hole Provided for
Tailpiece
Tailpiece
“□’’-Channel
Bracket
NOTE
Wheel hanger bracket must be re­
moved before the “U”-channe[ can
be pivoted down.
2. Pivot the “U”-channel bracket down. Place the
----- tailpiece in place in holes provided. See figure 4.
FIGURE 4.
3. Replace hex bolts in frame, which were removed
----- in step 1. Tighten securely. See figure 5.
4. Remove hex bolts and belleville washers from front
of frame. See figure 5.
FIGURE 5.
Left Hand
® Hex Bolt
and Belleville
Washer
Hex Bolt (D)
Belleville Washer (E)
Lock Washer (F)
Hex Nut (G)
HANDLE ASSEMBLY
1.----- Place the right and left hand handles in place
------- against the tiller frame. See figure 6.
2
.
NOTE
The left hand handle has the
clutch grip preassembled. Refer to
figure 1.
Start the hex bolt and belleville washer by hand
(removed in step 4) in the bottom hole in handle.
Secure the top hole in handle with hex bolt (D),
belleville washers (E), lock washer (F) and hex nut
(G). See figure 6.
FIGURE 6.