MTD 241-645A - Manual (Page 4)

TOOLS REQUIRED:
(1) Raw Hide or Plastic Hammer
(1) 1-1/8" Wrench or Adjustable Wrench
(1) 3/4" Wrench
OTHER MATERIALS NEEDED:
(A) One gallons of regular grade gasoline (for engine)
(B) 1-1/2 pints of SAE 30 or 10W oil (for engine)
(C) Approximately 3 gallons of Dexron II automatic
transmission fluid. (May be obtained at your
local service station or auto parts store).
(E) Automotive Grease
(F) Funnel
___________ F
»iiSliiiliil
FIGURE 1
ASSEMBLY INSTRUCTIONS
1. Pack the tapered roller bearings with automotive
grease.
NOTE
Do Not put any grease in the hub caps.
2. Place one spacer (A) on axle, next one wheel, and
tapered roller bearing (B). See figure 2.
LIST OF CONTENTS IN HARDWARE PACK:
See figure 1.
(A) (2) Spacers
(B) (2) Tapered Roller Bearings
(C) (2) Hex Castle Nuts 3/4-16 Thread
(D) (2) Cotter Pins
(E) (2) Hub Caps
(F) (I) Shoulder Bolt
(G) (I) Flat Washer FIGURE 2