NordicTrack AUDIOSTRIDER 800 NTEL7706.1 - Manual (Page 14)

Measure your heart rate if desired. Turn on the fan if desired.
If there are
sheets of clear
plastic on the
metal contacts
on the handgrip
pulse sensor,
remove the plas­
tic. In addition,
make sure that
your hands are
clean. To mea­
sure your heart rate, hold the handgrip pulse sen­
sor with your palms resting against the metal con­
tacts. Avoid moving your hands or gripping the
contacts tightly.
To turn on the fan at high speed, press the Fan
button. To turn on the fan at low speed, press the
Fan button a second time. To select the auto
mode, press the Fan button a third time; while the
auto mode is selected, the speed of the fan wilt
automatically increase or decrease as you
increase or decrease your pedaling speed.
Pivot the fan louvers above the display upward or
downward to direct the airflow from the fan.
To turn off the fan, press the Fan button again.
Note: If the pedals do not move for about thirty
seconds, the fan will automatically turn off to con­
serve the batteries.
When your pulse is detected, your heart rate will
be shown in the display. For the most accurate
heart rate reading, hold the contacts for at least 15
seconds.
If your heart rate is not shown, make sure that
your hands are positioned as described. Be care­
ful not to move your hands excessively or to
squeeze the metal contacts tightly. For optima!
performance, clean the metal contacts using a
soft cloth; never use alcohol, abrasives, or
chemicals to clean the contacts.
H When you are finished exercising, the console
will turn off automatically.
If the pedals do not move for several seconds, a
series of tones will sound and the console will
pause.
If the pedals do not move for about five minutes,
the console will turn off and the displays will be
reset.
14