NordicTrack AUDIOSTRIDER 800 NTEL7706.1 - Manual (Page 9)

9. Apply a small amount of grease to the axle on
the Left Link Arm (30), to the axle on the Left
Pedal Arm (32), and to a Wave Washer (100).
Slide the Wave Washer (100) onto the axle on
the Left Pedal Arm (32). Next, slide a Link Arm
Spacer (74) onto the axle on the Left Link
Arm (30).
Then, insert the axle on the Left Link Arm (30)
into the left Upper Body Leg (24) while sliding
the Left Link Arm onto the axle on the Left Pedal
Arm (32).
Repeat this step with the Right Link Arm (31).
10. Attach the Left Link Arm (30) to the Left Pedal
Arm (32) with an M8 x 15mm Button Screw
(106), an M8.5 X 16mm x 1.5mm Washer (103),
and an Axle Cover (66).
Attach the Left Link Arm (30) to the left Upper
Body Leg (24) with an M8 x 25mm Button
Screw (110), two M8.5 x 16mm x 1.5mm
Washers (103), two Axle Covers (66), a Link
Arm Spacer (74), and an M8 x 15mm Button
Screw (106) as shown.
Attach the Right Link Arm (31) in the same
way.
11. The Console (11) can be operated with four
1,5V “D” batteries (not included); alkaline batter­
ies are recommended. Locate the two battery
covers on the back of the Console. Press the
tabs on the battery covers, and remove the bat­
tery covers. Next, insert two batteries into each
battery compartment; make sure that the bat­
teries are oriented as shown by the symbols
inside the battery compartments. Then, reat­
tach the battery covers.
The Console (11) can also be operated with a
regulated 6-volt DC 2-amp power supply (not
included). To purchase a power supply, cal!
the toll-free telephone number on the front
cover of this manual. To avoid damaging the
console, use only a manufacturer-supplied
power supply. Plug one end of the power sup­
ply into the jack on the elliptical exerciser; plug
the other end into an outlet installed in accor­
dance with all local codes and ordinances.
12. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.