Tire pressure, Operation, Before starting – MTD 24642-A User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HAI'/iMER
FIGURE 4
ENGAGEMENT HANDLE
ENGAGEMENT ROD
HAIR PIN COTTER
FERRULE
4. Place hub cap (E) in position on wheel and tap on
with a plastic hammer. See figure 4.
5. Repeat steps 1 through 4 for the second wheel.
6. Secure engagement handle to beam with shoulder
bolt (F) and flat washer (G). See figure 5.
7. Remove the hair pin cotter from ferrule.
8. Secure engagement rod to engagement handle
with hair pin cotter. See figure 5.
TIRE PRESSURE
FOR SHIPPING PURPOSES, THE TIRES ON YOUR
UNIT MAY BE OVER-INFLATED. TIRE PRESSURE
SHOULD BE REDUCED BEFORE UNIT IS PUT
INTO OPERATION. RECOMMENDED PRESSURE
SHOULD BE APPROXIMATELY 15 P.S.I. EQUAL
TIRE PRESSURE SHOULD BE MAINTAINED ON
ALL TIRES. MAXIMUM TIRE PRESSURE IS 30
P.S.I.
FIGURES
OPERATION
BEFORE STARTING
NOTE
Refer to engine manual packed with
log splitter for complete instructions
for the care and maintenance of engine.
READ DIRECTIONS CAREFULLY.
1. Fill oil sump with approximately 1-1/2 pints of
SAE 30 oil, or to full mark on dipstick. See Figure
6.
Use MS classification oil. Do not use oils
marked only MM or ML or unmarked. Above
32°, use SAE 30; below 32° use SAE 10W-30.
These recommendations must be followed for
\ best performance and long life.
During initial break-in period, oil level should be
watched closely. Refer to the engine manual.
2. Fill fuel tank, using clean, fresh,
regular
grade
automotive gasoline. Fill tank completely.
FIGURE 6