Assembly instructions, Tools required, Other materials needed – MTD 24638S User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
G-
H-
FIGURE 1
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
(1) Raw Hide or Plastic Hammer
(1) 3/4" Wrench or Adjustable Wrench
(1) Pair of Pliers
OTHER MATERIALS NEEDED
One gallon of regular grade gasoline (for engine)
1-1/2 pints of SAE 30 or 10W30 oil (for engine).
Approximately 2 gallons of Dexron TL automatic
transmission fluid (may be obtained at any local
service station or auto parts store).
Funnel
CONTENTS OF HARDWARE PACK (See figure 1):
A
(1)
Shoulder Bolt
B
(1)
Rubber Washer
C
(1)
Lock Washer
D
(1)
Hex Nut
E
(1)
Ferrule
f
(1)
Hairpin Cotter
G
(2)
Flat Washers
H
(1)
Cotter Pin
1
(2)
Axle Push Caps
J
(1)
Spacer
LOOSE PARTS IN CARTON (See figure 2):
L
(2)
Wheels
M
(1)
Axle Shaft
------ s
N
(1)
Engagement Rod
0
(1)
Engagement Handle
figure
2
AXLE PUSH CAP (I)
FIGURES
1.
Remove log splitter and loose parts from carton.
Make certain all parts and literature have been
removed from the carton before the carton is
discarded.
2.
Using a raw hide or plastic hammer, tap one axle
push cap (I) on one end of axle shaft (M). See
figure 3.
3. Slide one wheel onto the axle shaft.
4.
Slide the axle through the frame from the right
hand side of the splitter (as viewed from standing
behind it).