MTD 24638S - Manual (Page 6)

LEFT HAND SIDE
OF SPLITTER
FIGURE4
Slide spacer (J) onto axle shaft on the left hand
side of the splitter. Spacer should be on the engine
side of the splitter. See figure 4. Place the other
wheel on the axle.
6. Secure wheel to axle with push cap (I). See figure-
5.
PUSH CAP (I)
FIGURE 5
7. Hook the bent end of the engagement rod (N)
into the lever on top of the pump. See figure 6.
Next, place one flat washer (G) over the rod.
Insert the cotter pin (H) into the hole in the rod
and secure by bending the ends of the cotter pin
in opposite directions.
FIGURE 6