Asslivlblt, Install seat (see fig. 3), Check tire pressure – Poulan 166120 User Manual
Page 7: Check deck levelness, Check for proper position of all belts, Check brake system, How to set up your tractor
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSLiVlBLT
HOW TO SET UP YOUR TRACTOR
CHECK B4T? £RY (See Fig. 2)
•
Lift seat pan to raised position and open battery box
door.
•
If this battery is pul into sen/ice after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in CUSTOMER RESPONSIBILITIES
section of this manual for charging 'nstructions).
SEAT PA!
LABLE
BATTERY
BOX DOOFT"
TERMINAL
TERMINAL
FIG. 2
INSTALL SEAT (See Fig. 3)
Adjust seat before tightening adjustment bolt.
Remove cardboard packing on seat pan.
Place seat on seat pan and assemble shoulder
bolt.Tighten shoulder bolt securely.
Assemble adjustment bolt, lockwasherand flat washer
loosely. Do not tighten.
Lower seat into operating position and sit on seat.
Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way
down.
Get off seat without moving its adjusted position.
Raise seat and tighten adjustment bolt securely.
I NIA L
L
[IF.
FX'
c.,
Th IT ill)' vrlIf ( I <
i/hon
.f I I r t! it
Dperating mow
in
pthe
mower d'
proper position when operating mower. Be sure they are
prop! 11/ H~)M .lecitorn LTt ( ^timi.r. oi. w. I pM.'riTunce.
•
Assemoie gauge wneeis witn tractor on a TiaL level
surface.
•
Adjust mower to desired cutting height (See ‘TO AD
JUST MOWER CUTTING HEIGHT” in the Operation
section of this manual).
•
With mower in desired height of cut position, gauge
wheels should be assembled so they are slightly off the
ground. Install gauge wheel in appropriate hole with
shoulder bolt, 17/32 washer, 3/8 washer, and 3/8-16
locknut and tighten securely.
——'
•
Repeat for opposite side installing gauge-wheel in
same adjustment hole.
CHECK TIRE PRESSURE
The tires on your tractor were overinflated at the factory for
shipping purposes. Correct tire pressure is important for
best cutting performance.
• Reduce tire pressure to PSI shown in “PRODUCT
SPECIFICATIONS” on page 3 of this manual.
CHECK DECK LEVELNESS
For best cuttino results, mower housing should be properly
leveled. See““TO LEVEL MOWER HOUSING” in the
Service and Adjustments section of this manual.
CHECK FOR PROPER POSITION OF ALL
BELTS
See the figures that are shown for replacing motion and
mower blade drive belts in the Service and Adjustments
section of this manual. Verify that the belts are routed
correctly.
CHECK BRAKE SYSTEM
After you learn how to operate your traotor, check to see
that the brake is properly adjusted. See ‘TO ADJUST
BRAKE" in the Service and Adjustments section of this
manual.