Checking engine oil level, Change engine oil, Change oil filter – Generac Power Systems Air-cooled Recreational Vehicle Generator 9734-3 User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Generac NP-66LPG Recreational Vehicle Generator

This section includes information about simple maintenance
which includes the following tasks:

• Checking engine oil level.

• Changing engine oil.

• Changing oil filter.

• Changing the air cleaner.

• Cleaning the air intake screen.

• Cleaning spark plugs.

CHECKING ENGINE OIL LEVEL

Check engine crankcase oil level at least every eight hours of

operation, or before each use (Figure 7).

• Be sure the generator is as level as possible.

• Remove oil dipstick and wipe dry with clean, lint-free cloth.

• Install and tighten oil dipstick, then remove again.

• Oil should be at dipstick FULL mark. If necessary„add the

recommended oil to the FULL mark only. DO NOT FILL
ABOVE “FULL” MARK.

Install and tighten oil dipstick cap before operating the

engine.-

NOTE:

See “Engine Oil Requirements" on Page 12 for rec­

ommended oiis.

Figure 7 — Oil Dipstick and Fill Tube

CHANGE ENGINE OIL

Change engine oil after the first 25 hours of operation (after

the 25 hour break-in period. Page 8). Thereafter, change oil
every 50 operating hours. Change oil more frequently if oper-

-.ating consistently under heavy load or at high ambient

temperatur^

• Warm up erigine for at-least.five minutes, then shut down.

With engine still warm from running, remove capifrom oil

drain hose (Figure 8). Drain oil completely into a suitable

container.

When oil has drained, install and tighten drain hose cap.

Remove oil dipstick and fill crankcase with the recom­

mended oil (See Page 12). The engine crankcase can hold
about 1.4 liters. DO NOT FILL ABOVE “FULL” MARK.

Install and tighten dipstick cap before operating engine.

Figure 8 — Location of Oil Drain Plug

OIL DFIAIN
PLUG

CHANGE OIL FILTER

Replace the engine oil filter after the first 25 hours of opera­

tion, every 100 operating hours thereafter.

• Turn oil filter counterclockwise to remove (Figure 9).

• Coatgasketof new filter with engine oil.

• Turn new filter clockwise until its gasket contacts tightly with

the filter adapter. Then tighten with an additional 3/4 to one
turn by hand.

• Run engine.and check for leaks.

NOTE: Check oil level and fill to full mark after checking for
leaks. Filter will retain some oil.

Figure 9 — Engine Oil Filter

TO LOOSEN

Recreational

V e h i c l e G e n e r a t o r

13

Advertising