Applying loads to generator, Letting the engine stabilize, Do not overload the generator – Generac Power Systems Air-cooled Recreational Vehicle Generator 9734-3 User Manual

Page 9: Wattage reference guide

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Generac NP-66LPG Recreational Vehicle Generator

APPLYING LOADS TO GENERATOR

When applying electrical loads to the generator, observe these
guidelines;

• Before applying electrical loads, let the generator stabilize

and warm up for a minute or two.

• DO NOT overload the generator.

■ LETTING THE ENGINE STABILIZE

The generator supplies correct rated frequency and voltage
only at the proper governed speed. Some electrical appli­
ances may be extremely sensitive to voltage and frequency.
Incorrect frequencies and/or voltages can damage those appli­
ances.

If electrical loads are applied at reduced operating speeds, such

loads imposed on the engine when sufficient power is not avail­
able may shorten engine life. Never turn ON electrical loads
until after the generator engine has started and stabilized

ON-speed.

■ DO NOT OVERLOAD THE GENERATOR

You can read the rated wattage/amperage capacity of your
generator on the generator data plate (see “Identification
Record” on Page 1).

/^plying electrical loads in excess of the unit’s rated capac­
ity will cause the engine-generator to automatically shutdown.

To avoid overloading, add up the wattage of all connected elec­
trical lighting, appliance, tool and motor loads. This total should
not be greater than the generator’s rated wattage capacity.

• Most lighting, appliance, tool and motor loads indicate their

requir^ watts on their nameplate or data plate. For light
bulbs, simply note the wattage rating of the bulb.

• If a load does not show its rated wattage, multiply that load’s

rated VOLTS times AMPS to obtain WATTS.

• Induction type motors (such as those that run the vehicle’s

furnace fan, refrigerator, air conditioner, etc.) need about 2-

1/2 times more watts of power for starting than for running
(for a few seconds during motor starting). Be sure to allow

for this when connecting electrical loads to the generator.

Rrst, figure the watts needed to start electric motors in the

system. To that figure, add the running wattages of other
items that will be operated by the generator.

• Do not apply heavy electrical loads for the first two or three

hours of operation.

WATTAGE REFERENCE GUIDE

RUNNING

WATTS

*Air Conditioner (12.000

Btu)..................................................1700

Battery Charger (20 amp)....................................................................... 500

Belt Sander (3")...................................................................................... 1000

Chain Saw......................................... ..................................................... 1200

Circular Saw (6-12")...............................................................800 to 1000

Coffee Maker..........................................................................................1000

•Compressor (1 HP)...............................................................................2000

•Deep Freeze............................................................................................ 500

Disc Sander (9")......................................................................................1200

Electric Range (one element)............................................................... 1500

Electric Skillet........................................................................................ 1250

•Furnace Fan (1/3 HP).......................................................................... 1200

Hair Dryer............................................................................................ 1200

Hand Drill (1")......................................................................................... 1100

Hedge Trimmer........................................................................................450

Impact Wrench..:...................................................................................... 500

RUNNING

WATTS

Lawn Mower...........................................................................................1200

Light Bulb...................................................................................................100

Microwave Oven..................................................................................... 700

•Milk Cooler............................................................................................ 1100

Oil Burner on Furnace..............................................................................300

Oil Fired Space Heater (140,000 Btu).....................................................400

•Paint Sprayer, Airless (1/3 HP)...............................................................600

Radio.............................................................................................50 to 200

•Refrigerator.........................................................................................v. 600

Slow Cooker................... ......................................................................... 200

•Submersible Pump (1-1/2 HP)......................................................... ..2800

•Submersible Pump (1 HP)......;........................ .2000

Table Savy (10”).................................................................. 1750 to 2000

Television........................................................ .................... 1750 to 2000

• Allow 2-1/2 times the listed watts for starting these
devices.

R e c r e a t i o n a l V e h i c l e G e n e r a t o r

Advertising